ASROCK Z690 PG Riptide - Page 85

English
78
Oset Prex
Sets the oset value as positive or negative.
Uncore Voltage Mode
Selects between adaptive and Override Voltage modes. In Override Mode the volt-
age selected will be applied over all operating frequencies. In Adaptive Mode the
voltage is interpolated only in turbo mode. Uses Mailbox 0SR 0x150, cmd 0x10,
0x11.
Uncore Extra Turbo Voltage
Species the extra turbo voltage applied while SA Uncore is operating in turbo
mode. Uses Mailbox MSR 0x150, cmd 0x10, 0x11. Range 0-2000 mV.
Uncore Voltage Oset
Species the Oset Voltage applied to the Uncore domain. is voltage is specied
in millivolts. Uses Mailbox MSR 0x150, cmd 0x11. Range -500 to 500 mV.
Oset Prex
Sets the oset value as positive or negative.
Save User Default
Type a prole name and press enter to save your settings as user default.
Load User Default
Load previously saved user defaults.
Save User UEFI Setup Prole to Disk
It helps you to save current UEFI settings as an user prole to disk.
Load User UEFI Setup Prole from Disk
You can load previous saved prole from the disk.