Assa Abloy Yale EF-PIR User Manual

Description
1. Learn/Test Button
To enter Test mode: Press once in Standby
mode. The LED will light up for 2 seconds
whenever motion is detected. Test mode
lasts for 3 minutes.
2. LED Indicator
3. Knockouts for Wall/Corner Mounting
4. Jumper 2 = Supervision Enable/Disable
5. Jumper 3 = Motion High/Low Sensitivity
6. Tamper Switch with spring
7. 3x 1.5V AAA Alkaline Batteries
8. Cover securing screw
9. Battery tab
Inside the Box
• 1 x PIR Motion Detector.
• 4 x wall plugs & screws.
• 3 x 1.5V AAA alkaline batteries (pre-fitted).
PIR Motion Detector
(EF-PIR)
smart
Living
For more information on this product
and Yale Smart Living Range visit
www.yale.co.uk/smart-living
Consumer Support: info@yale.co.uk
2
The 2 year guarantee for this
product is active from the date
of purchase (A copy of this
guarantee is available on our
website).
ale
Y
Program your PIR before installation and test
afterwards. Please see your Alarm user manual.
• Mount in a position such that an intruder
would normally move across the PIRs field
of view.
• Height should be between 1.9 and 2 metres
above floor level.
• Location in a corner will ensure wider room
coverage.
• Do not mount the PIR where its field of view
will be obstructed e.g. by curtains, ornaments
etc.
• Do not point directly at sources of heat
e.g. fires or boilers, and do not position
directly above radiators.
• Avoid mounting the PIR directly facing a
window.
• Do not point the PIR at a door protected
by a Door/Window Contact.
1
2
8
4
5
6
7
3
3
9
Programming & Location

Assa Abloy Yale EF-PIR Specifications

General

Wireless Frequency	868 MHz
Detection Range	12 meters
Detection Angle	110 degrees
Battery Life	Up to 3 years
IP Rating	IP44
Type	PIR Motion Sensor
Power Supply	3V Lithium Battery
Mounting	Wall Mount
Compatibility	Yale Smart Home Systems

Summary

Device Description and Components

Learn/Test Button Function

Describes how to enter Test mode and its duration, along with LED feedback.

LED Indicator

Indicates the function of the device's LED light for status feedback.

Mounting Knockouts

Details the knockouts available for wall or corner mounting the detector.

Supervision Jumper Setting

Explains Jumper 2 for enabling or disabling supervision signals.

Sensitivity Jumper Setting

Explains Jumper 3 for adjusting motion detection sensitivity.

Tamper Switch

Describes the tamper switch mechanism with its spring.

Battery Specification

Details the type and quantity of batteries required for operation.

Cover Securing Screw

Identifies the screw used for securing the device cover.

Battery Tab

Identifies the tab used for battery insertion or removal.

Programming and Location Guide

Device Operation Details

Supervision Jumper Functionality

Explains how Jumper 2 controls periodic supervisory signals to the control panel.

Motion Sensitivity Jumper

Describes Jumper 3's function to increase or decrease motion sensitivity.

Sleep Timer Feature

Details the automatic sleep time preventing retransmission for one minute after detection.

LED Indicator Behavior

Explains normal operation and conditions triggering LED flashes (low battery, tamper, test mode).

Technical Specifications

Environmental Conditions

Specifies operating temperature, humidity, and indoor-only use.

Radio Frequency

States the radio frequency used by the device (868MHz FM).

Motion Detection Range

Specifies the angular detection range of the PIR motion sensor (110 degrees).

Compatibility

Lists compatible Yale alarm kits (SR and EF Series).