Associated RC10 - Transmission Assembly (Bag C)

7
:: :: Transmission Transmission BuildBuild - Bag C - Bag C -- Step 1Step 1
:: :: Transmission Transmission BuildBuild - Bag C - Bag C -- Step 2Step 2
:: :: Transmission Transmission BuildBuild - Bag C - Bag C -- Step 3Step 3
Build 2
Key drive gear pin
into slot on spine
plate!
!
Drive gear
pivot pin
Drive gear
pivot
RC10 idler
gear pivot
Bowed
e-clip
Washer
5mmx 0.17mm
Oilite bushing
3/16x5/16x1/4
RC10
spine
plate
Drive gear
pivot nut
!
!
1
2
Curved side of
bowed E-Clip
should point
outwards!
NOTE: Install washer (1)
before bowed e-clip (2)
!
RC10 internal
retaining clip
4-40 x 3/16
BHCS
RC10 axle
drive gear
x2x2
Remove any burrs
if necessary with
hobby knife!
!
Snap internal
retaining clip
into groove
with internal
snap ring
pliers!
Racer’s Tip:
Use a small amount of
CA glue on idle pivot hole.
A little in-out
play is normal on
the outdrives
!
!
!