5. Using a Drill with 1/4" Drill Bit, drill 1/4" holes at Marks #1 & #3.
SureLock Installation Instructions
Be sure to follow and complete all (18) steps listed
1. With garage door closed count the garage door rollers
(wheels) inside the garage door track. You will be
mounting the SureLock just above the second
door/track roller up from the floor (Note: this can be
done on either side of the garage door, it's your choice).
2. Use a marker and make a "Dot" inside the track just
above the second door/track roller (in center of track),
once done open your garage door.
3. Unplug garage door opener from wall/ceiling outlet.
4. Now place the supplied template inside the track and align Hole #3 on
template with previously placed "Dot" and place additional marks on
inside of track at Hole#1 & Hole#2.
D
r
i
l
l
H
o
l
e
T
e
m
p
l
a
t
e
#1
Drill 1/4” Hole
#2
Drill 1” Hole
Using The Supplied Hole Saw
#3
Drill 1/4” Hole
6. Using the supplied 1" Hole Saw, drill a 1” hole at Mark #2.
(make sure to debur holes using a small round file)
Hole #1(1/4”)
Hole #2(1”)
Hole #3(1/4”)
Align with Dot
Note: Use center punch to locate drill bit prior to drilling hole.
Note: Use center punch to locate drill bit prior to drilling hole.
To Next Page
Loading...
Need help?
General