Safety
IB-2003
eries 40 Trans
ite-
tationary
onveyor
23
Hydraulic Safety
1. Always place all controls
in neutral before servicing
hydraulic system.
2. Replace any worn, cut,
abraded, flattened or
crimped hoses or steel
lines.
3. Do not attempt any
makeshift repairs to the
hydraulic lines, fi ttings or
hoses by using tape,
clamps or cements.
The hydraulic system
operates under extremely
high-pressure. Such
repairs will fail suddenly
and create a hazardous
and unsafe condition.
4. Wear proper hand and
eye protection when
searching for a hydraulic
leak. Use a piece of wood
or cardboard as a
backstop instead of hands
to isolate and identify a
leak.
5. If injured by a
concentrated high-
pressure stream of
hydraulic fluid, seek
medical attention
immediately. Serious
infection or toxic reaction
can develop from
hydraulic fl uid piercing the
skin surface.
Transport Safety
1. Make sure you are in
compliance with all local
regulations regarding
transporting equipment
on public roads and
highways.
2. Make sure that all the
lights and refl ectors that
are required by the local
highway and
transportation authorities
are in place, are clean and
can be seen clearly by all
overtaking and oncoming
traffi c.
3. Do not allow anyone to
ride on the impact crushing
plant during transport.
4. Do not exceed 55 mph
when transporting the
machine. Reduce speed
on rough roads and
surfaces.
5. The machine is not
grounded. Electrocution
can occur without direct
contact. Stay away from
overhead power lines.
Tire Safety
1. Failure to follow proper
procedures when mounting
a tire on a wheel or rim can
produce an explosion which
may result in serious injury
or death.
2. Do not attempt to mount a
tire unless you have the
proper equipment and
experience to do the job.
3. Have a qualifi ed tire dealer
or repair service perform
required tire maintenance.
Explosive Materials
This machine shall not be used
to process or handle explosive
materials.
Working Environment
The equipment must be
allowed to cool before any
type of service is performed.
Noise Emission
The operator shall measure the
sound power level immediately
after machine start-up and
at all operating positions. If
the measurement is above
the permitted level, all people
will wear personal protective
equipment (ear protection).
To Next Page
Loading...
Need help?
General
