Astralpool EvoLine 10 - Electrical Safety Precautions


WARNINGS ASSOCIATED WITH ELECTRICAL APPLIANCES
• Deactivating, eliminating or by-passing any of the safety mechanisms integrated into the appliance shall
automatically void the warranty, in addition to the use of spare parts manufactured by unauthorised third-
party manufacturers.
• Do not spray insecticide or any other chemical (inammable or non-inammable) in the direction of the
appliance, as this may damage the body and cause a re.
• Do not touch the fan or moving parts and do not place any objects or your ngers in the vicinity of the
moving parts during operation of the appliance. Moving parts can cause serious injury or even death.
• The electrical supply to the appliance must be protected by a 30 mA dierential Residual Current protection
Device (RCD), complying with the standards and regulations in force in the country in which it is installed.
• Do not use any extension lead when connecting the appliance; connect the appliance directly to a suitable
power supply circuit.
• If a stationary appliance is not tted with a supply cord and a plug, or with other means for disconnection from
the supply mains having a contact separation in all poles that provide full disconnection under overvoltage
category III conditions, the instructions shall state that means for disconnection must be incorporated in the
xed wiring in accordance with the wiring rules.
• A Suitable disconnecting means, which complies with all local and national requirements for over-voltage
category III, and which disconnects all poles of the supply circuit, must be installed in the supply circuit to
the appliance. Such disconnecting means is not provided with the appliance and must be provided by the
installation professional.
• Before carrying out any operations, check that:
- The voltage indicated on the appliance information plate corresponds to the mains voltage.
- The power grid is adapted to the power requirements of the appliance, and is grounded.
- The plug (where applicable) is suitable for the socket.
• In the event of anormal operation or the release of unusual odours from the appliance, turn it o immediately,
unplug it from its power supply and contact a professional.
• Before any access to the appliance for service or maintenance, ensure that it is switched o and completely
disconnected from the power supply. Furthermore, in addition to conrming that the heating priority (where
applicable) is deactivated, ensure that any other equipment or accessories connected to the appliance are
also disconnected from the power supply circuit.
• Do not disconnect and reconnect the appliance to the power supply when in operation.
• Do not pull on the power cord to disconnect it from the power supply.
• If the power cord is damaged, it must be replaced by the manufacturer, its technician or a qualied person
to guarantee safety.
• Do not perform maintenance or servicing operations on the appliance with wet hands or if the appliance is
wet.
• Before connecting the appliance to the source of supply, ensure that the terminal block or supply socket to
which the appliance will be connected is in good condition and is not damaged or corroded in any way.
EN