WARNING
WARNING: Read and understand all instructions.
Failure to follow all instructions listed below may result in serious injury.
WARNING: The warnings, cautions and instructions discussed in this instruction manual
cannot cover all possible conditions or situations that could occur. It must be understood
by the operator that common sense and caution are factors which cannot be built into
this product, but must be applied by the operator.
Maintain your workbench. It is recommended that the general condition of any workbench be examined
before it is used. Keep your workbench in good repair by adopting a program of conscientious repair and
maintenance. Have necessary repairs made by qualified service personnel. Wipe away dirt and dust from
the workbench on a regular basis.
CAUTION: Do not allow persons to operate or assemble this workbench until they have
read this manual and have developed a thorough understanding of how the unit works.
Product Type:Model:
55670
7-IN-1 WORKBENCH
Page 2
PRODUCT LAYOUT
Sawhorse Holes
2-IN-1 Handle
Fixed Wheels
Compass
Ruler
Towing Hole
Universal Wheels
w/ Brakes
Aluminum Legs
Self Adjusting Leg Pads
Tool Tray
Work Platform Size: 109 x 55cm (3'6.9" x 1'9.7")
Work Height: 56/80cm (1'10"/2'7.5")
Loading Capacity:
Workbench/Sawhorse Mode: 150kgs (330lbs)
Scaffold/Platform Mode: 250kgs (550lbs)
Car Creeper & Dolly Mode: 150kgs (330lbs)
Hand Truck Mode: 150kgs (330lbs)
Net Weight: 14kgs / 30.9lbs
Read carefully and understand all ASSEMBLY AND OPERATION INSTRUCTIONS before operating. Failure
to follow the safety rules and other basic safety precautions may result in serious personal injury.
This machine is designed for certain applications only. The distributor cannot be responsible for issues
arising from modification. We strongly recommend this machine not be modified and/or used for any
application other than that for which it was designed. If you have any questions relative to a particular
application, DO NOT use the machine until you have first contacted the distributor to determine if it can or
should be performed on the product.
TECHNICAL SPECIFICATIONS
To Next Page
Loading...