EasyManua.ls Logo

AstroAI EPA1020-0612 - 4-Stage Charging Process; Stage 1: Initialization; Stage 2: Bulk Charge; Stage 3: Absorption

AstroAI EPA1020-0612
5 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
- 2 -
Brief: This device is 4 stages smart battery charger by
Microprocessor controlled with switch mode for 6V and 12V is selectable
output .it is ideal for charging your CAR,MOTORCYCLE AND RIDE-ON
TOY batteries,suit for type of batteries included AGM GEL VRLA SLA
WET and deep-cycle.
4-stage chargingprocess
Stage 1:initialization,when the charger power on then it start self-check
anddetectthe batterycorrectconnect.low outputvoltagewithout
batteryFaultLEDislight,pleaseCHECKTHEPOLARITYIS
CORRECT.
Stage2:Bulkcharge,usingthechargerhighestrated currentforthetype
ofbatteryinuseuntilitreaches80%capacity(LEDs50%
Blinking,100%OFF)
Stage3:Absorption,the output voltage is limited to 7.3V(6V battery)or
14.5V(12Vbattery)whilecurrentdeclinesas thebatterycharges
toitsfullcapacitywithoutoverheating(LEDs50%
ON ,100% Blinking)
Stage4:Float,Atthisstage,thebatteryisfullychargedand the charger
maintainsthebatterythroughpulsecharging(LEDs50%
ON,100%ON)
IMPORTANT WARNING:
Before charging,make sure the correct battery voltage with the
device voltage as same.