Asus A7A266 - Page 38

38 ASUS A7A266 User’s Manual
3. HARDWARE SETUP
Connectors
3. H/W SETUP
12) Wake-On-LAN Connector (3-pin WOL_CON)
This connector connects to a LAN card with a Wake-On-LAN output, such as
the ASUS PCI-L101 Ethernet card (see 7. Appendix). The connector powers up
the system when a wakeup packet or signal is received through the LAN card.
IMPORTANT: This feature requires that the Wake-On-LAN or PCI Modem
feature is enabled (see 4.5.1 Power Up Control) and that your system has an
ATX power supply with at least 720mA +5V standby power.
0 10 1
A7A266
A7A266 Wake-On-LAN Connector
IMPORTANT: Requires an ATX power
supply with at least 720mA +5 volt
standby power.
+5 Volt Standby
PME
Ground
WOL_CON
13) Wake-On-Ring Connector (2-pin WOR)
This connector connects to internal modem cards with a Wake-On-Ring output.
The connector powers up the system when a ringup packet or signal is received
through the internal modem card. NOTE: For external modems, Wake-On-Ring
is detected through the COM port.
IMPORTANT: This feature requires that the Wake-On-LAN or PCI Modem
feature is enabled (see 4.5.1 Power Up Control) and that your system has an
ATX power supply with at least 720mA +5V standby power.
0 10 1
A7A266
A7A266 Wake-On-Ring Connector
WOR
RI# Ground
21