20
ASUS A7N266 User’s Manual
3. HARDWARE SETUP
3. H/W SETUP
Motherboard Settings
7) Onboard Network Setting (LAN_EN) (LAN Models only)
The onboard LAN network chip (RTL8100) may be activated or deactivated.
The operational default, [1-2], already enables the network function. Reset to
[2-3] to disable the onboard ethernet.
A7N266
0 10 10 1
®
A7N266 On Board LAN Setting
LAN_EN
Enable
12
Disable
23
(Default)
6) Bass / Center Setting (BCS1, BCS2)
Use these jumpers in conjunction with the C-Media PCI Audio Driver to adjust
output for 4 or 6 speaker audio. Since no audio standard exists for the three
pick-up surfaces on male audio jacks, it may be necessary to switch jumpers
from the default position, Center/Bass, to Bass /Center in order to reroute signals
to the Line-In, Line-Out and Mic sockets. Make a test using the C-Media Audio
Driver software setup available on the Support CD.
A7N266
0 10 10 1
®
A7N266 Bass Center Setting
CENTER / BASS
1
2
BCS1
BCS2
BASS / CENTER
2
BCS1
BCS2
3
(Default)
To Next Page
Loading...
