Disassembly procedure
2 - 11
Top Case Module
The illustrations below show how to disassemble and remove the top case module of the
notebook. The module contains the top case itself and touch pad module.
Removing Top Case Module
1. Remove 2 screws [M2 * 4(L)] (back - coaxial cable cover) and carefully
remove the Cable Cover.
2. Remove 2 screws [M2 * 4(L)] and disconnect the Coaxial cable & Inverter
cable with tweezers.
3. Carefully pull out the Antenna from the bottom case.
4. Remove 2 screws [M2.5 * 8(L)] on rear side.
TOP CASE
MODULE
TOP CASE
MODULE
REMOVE
Coaxial cable
Inverter cable
To Next Page
Loading...
