Asus H110I-PLUS D3 - Page 46

2.5.6 EPU Power Saving Mode [Disabled]
ASUSEPU(EnergyProcessingUnit)setstheCPUinitsminimumpowerconsumption
settings.EnablethisitemtosetlowerCPUVCCINandVcorevoltagesandachievethebest
energysavingcondition.Congurationoptions:[Disabled][Enabled]
2.5.7 CPU SVID Support [Auto]
DisablingSVIDSupportstopstheprocessorfromcommunicatingwiththeexternalvoltage
regulator.Congurationoptions:[Auto][Disabled][Enabled]
2.5.8 DRAM Timing Control
ThesubitemsinthismenuallowyoutosettheDRAMtimingcontrolfeatures.Usethe
<+>and<->keystoadjustthevalue.Torestorethedefaultsetting,type[auto]usingthe
keyboardandpressthe<Enter>key.
Changingthevaluesinthismenumaycausethesystemtobecomeunstable!Ifthis
happens,reverttothedefaultsettings.
2.5.9 DIGI+ VRM
CPU Load-Line Calibration [Auto]
Load-lineisdenedbyIntelVRMspecicationandaffectstheCPUpowervoltage.TheCPU
workingvoltagewilldecreaseproportionallydependingontheCPUloading.Higherlevels
oftheload-linecalibrationcangetahighervoltageandabetteroverclockingperformance
butincreasestheCPUandVRMthermal.Selectfromlevel1to7toadjusttheCPUpower
voltagefrom0%to100%.Congurationoptions:[Auto][Level1][Level2][Level3][Level4]
[Level5][Level6][Level7]
TheboostedperformancemayvarydependingontheCPUspecication.Donotremove
thethermalmodule.
CPU Current Capability [Auto]
Allowsyoutocongurethetotalpowerrange,andextendstheoverclockingfrequencyrange
simultaneously.Congurationoptions:[Auto][100%][110%][120%][130%][140%]
Chooseahighervaluewhenoverclocking,orunderahighCPUloadingforextrapower
support.
CPU VRM Switching Frequency [Auto]
ThisitemaffectstheVRMtransientresponsespeedandthecomponentthermalproduction.
Select[Manual]tocongureahigherfrequencyforaquickertransientresponsespeed.
Congurationoptions:[Auto][Manual]
DONOTremovethethermalmodule.Thethermalconditionsshouldbemonitored.
2-18 Chapter 2: Getting started