EasyManuals Logo

Asus Lyra MAP-AC2200 User Manual

Asus Lyra MAP-AC2200
2 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Colors of Lyra
Light Cyan
Everything is good!
Red
Loss connection to the primary Lyra. Move it closer.
Quick Start Guide
Lyra
1
Connect Primary Lyra to Modem
Connect your modem to Lyra with the
network cable provided.
Unplug your cable / DSL
modem*. Remove the
battery if it has one.
* If you are using DSL for
internet, you will need
a username/password
from your Internet
service provider (ISP) to
properly congure your
router.
Power on your cable / DSL modem, and
check your cable / DSL modem LED lights
to ensure the connection is active.
Plug in the power adapter to Lyra and
wait until the LEDs turn to solid white to
ensure that your Lyra is ready for setup.
Primary Lyra
2
Setup your Lyra WiFi system
METHOD 1 Through App
Download the free ASUS Lyra app.
Launch the ASUS Lyra app on your mobile
device, and follow the instructions in just
a few moments.
* Make sure your device supports BLE,
Bluetooth 4.0 or above.
Connect PC/NB to your Lyra via WiFi
ASUS_XX_AMAPS. Open a web browser.
You will be redirected to the ASUS Setup
Wizard. If not, navigate to http://router.
asus.com
METHOD 2 Through Web GUI
Primary Lyra
Launch Lyra app and click the “+” icon on
the upper right corner, then choose Add
Lyra to current network and follow the
instructions to complete.
Adding other Lyra to current network
Press the Pairing button on the Primary Lyra
until the LED starts to blink green light.
Primary Lyra
Press the Pairing button on the second Lyra
until the LED starts to blink green light, then
turns solid light cyan, indicating the pairing
process is completed.
METHOD 2 Through Web GUI
METHOD 1 Through App
3
Orange
Loss connection to the Internet. Please check the cable connected with your modem.
Solid White
Lyra is ready for setup. It will start blinking when setting up with the app.
Random Breathing
Lyra is booting up or applying settings.
S13319 / Primera edición/ Septiembre 2017
Federal Communications Commission
Statement
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
• Thisdevicemaynotcauseharmfulinterference.
• Thisdevicemustacceptany interferencereceived,including
interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits
f or a class B dig ital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment o and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorientorrelocatethereceivingantenna.
• Increasetheseparationbetweentheequipmentandreceiver.
• Connecttheequipmentintoanoutletonacircuitdierentfrom
that to which the receiver is connected.
• Consultthedealeroranexperiencedradio/TVtechnicianforhelp.
WARNING!
Anychangesormodicationsnotexpresslyapprovedbytheparty
responsible for compliance could void the user’s authority to operate
the equipment.
Prohibition of Co-location
This device and its antenna(s) must not be co-located or operating in
conjunction with any other antenna or transmitter.
This equipment must be installed and operated in accordance with
provided instructions and the antenna(s) used for this transmitter must
be installed to provide a separation distance of at least 20 cm from all
persons and must not be co-located or operating in conjunction with
any other antenna or transmitter.
IMPORTANT NOTE:
RadiationExposureStatement:ThisequipmentcomplieswithFCC
radiationexposurelimitssetforthforanuncontrolledenvironment.
End users must follow the specic operating instructions for satisfying
RFexposurecompliance.TomaintaincompliancewithFCC
exposurecompliancerequirement,pleasefollowoperation
instruction as documented in this manual.
This device within the 5.15 ~ 5.25 GHz is restricted to indoor
operations to reduce any potential for harmful interference to
co-channel MSS operations.
Radio Frequency (RF) Exposure
Information
The radiated output power of the ASUS Wireless Device is below
theIndustryCanada(IC)radiofrequencyexposurelimits.The
ASUS Wireless Device should be used in such a manner such
that the potential for human contact during normal operation is
minimized.
This device has been evaluated for and shown compliant with
the IC Specic Absorption Rate (“SAR”) limits when installed in
specichostproductsoperatedinportableexposureconditions
(antennas are less than 20 centimeters of a person’s body).
This device has been certied for use in Canada. Status of the
listing in the Industry Canada’s REL (Radio Equipment List) can be
found at the following web address:
http://www.ic.gc.ca/app/sitt/reltel/srch/nwRdSrch.do?lang=eng
AdditionalCanadianinformationonRFexposurealsocanbe
found at the following web: http://www.ic.gc.ca/eic/site/smt-gst.
nsf/eng/sf08792.html
RF Exposure information
This device meets the EU requirements (2014/53/EU) on the
limitationofexposureofthegeneralpublictoelectromagnetic
elds by way of health protection.
Safety Notices
• Usethis productinenvironmentswithambient temperatures
between 0°C(32°F) and 40°C(104°F).
• Refertothe ratinglabel onthe bottomofyour productand
ensure your power adapter complies with this rating.
• DONOTplaceonunevenor unstableworksurfaces.Seek
servicing if the casing has been damaged.
• DONOTplace ordropobjectsontop anddo notshoveany
foreign objects into the product.
• DONOTexposetoorusenearliquids,rain,ormoisture.DONOT
use the modem during electrical storms.
• DONOTcovertheventsontheproduct topreventthe system
from getting overheated.
* Pairing feature only works with the Primary Lyra
device connecting to modem.
* While setting up through Web GUI, ensure that
you pair other Lyra hub(s) with the Primary Lyra
using the Pairing button.
S13319_Lyra_one-page_QSG_with_Safety_Notices.indd 1 2017/9/21 16:29:32

Other manuals for Asus Lyra MAP-AC2200

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Asus Lyra MAP-AC2200 and is the answer not in the manual?

Asus Lyra MAP-AC2200 Specifications

General IconGeneral
2.4 GHzYes
MIMO typeMulti User MIMO
Networking standardsIEEE 802.11a, IEEE 802.11ac, IEEE 802.11b, IEEE 802.11g, IEEE 802.11n
Ethernet LAN data rates10, 100, 1000 Mbit/s
Maximum data transfer rate2134 Mbit/s
InternalNo
PlacementTable
Product colorWhite
Antennas quantity7
WAN connectionEthernet (RJ-45)
USB 2.0 ports quantity0
Ethernet LAN (RJ-45) ports1
Security algorithmsWPA2-PSK
Compatible operating systemsWindows 10 86x64 Windows 8.1 86x64 Windows 8 86x64 Windows 7 86x64 Mac OS X 10.1 Mac OS X 10.4 Mac OS X 10.4 Mac OS X 10.5 Mac OS X 10.6 Mac OS X 10.7 Mac OS X 10.8
Antenna featuresIntegrated antenna
Output current2 A
Output voltage12 V
AC input voltage110 - 240 V
AC input frequency50 - 60 Hz
Cables includedLAN (RJ-45)
Weight and Dimensions IconWeight and Dimensions
Width149.8 mm
Height49.5 mm

Related product manuals