Asus M2N32-SLI DELUXE - Front Panel Audio Connector

ASUS M2N32-SLI Deluxe 2-29
• For a fully congured system, we recommend that you use a power supply
unit (PSU) that complies with ATX 12 V Specication 2.0 (or later version)
and provides a minimum power of 600 W.
• Do not forget to connect the 4-pin ATX +12 V power plug; otherwise, the
system will not boot.
• Use of a PSU with a higher power output is recommended when
conguring a system with more power-consuming devices. The system
may become unstable or may not boot up if the power is inadequate.
• The ATX 12 V Specication 2.0-compliant (500W) PSU has been tested
to support the motherboard power requirements with the following
conguration:
CPU: AMD FX-62
Memory 1024 MB DDR2-800 (x4)
Graphics card: PCI Express x16 NVIDIA 7950Gx2
Serial ATA device: SATA hard disk drive (x2)
Optical drives: DVD-RW
Parallel ATA device: IDE hard disk drive
• If you want to use two high-end PCI Express x16 cards, use a PSU with
500W to 600W power or above to ensure the system stability.
M2N32-SLI DELUXE
M2N32-SLI DELUXE
Analog front panel connector
AAFP
HD-audio-compliant
pin definition
Legacy AC’97
compliant definition
PORT1 L
PORT1 R PORT2 R
SENSE_SEND
PORT1 L
GND PRESENCE# SENSE1_RETUR SENSE2_RETUR
MIC2
MICPWR
Line out_R
NC
Line out_L
AGND NC NC NC
M2N32-SLI DELUXE
Analog front panel connector
AAFP
HD-audio-compliant
pin definition
Legacy AC’97
compliant definition
PORT1 L
PORT1 R PORT2 R
SENSE_SEND
PORT1 L
GND PRESENCE# SENSE1_RETUR SENSE2_RETUR AGND NC NC NC
10. Front panel audio connector (10-1 pin AAFP)
This connector is for a chassis-mounted front panel audio I/O module that
supports either HD Audio or legacy AC`97 audio standard. Connect one end
of the front panel audio I/O module cable to this connector.
• We recommend that you connect a high-denition front panel audio
module to this connector to avail of the motherboard’s high-denition audio
capability.
•
By default, this connector is set to AC’97. If you want to connect a High
Denition front panel audio module to this connector, set the Front Panel
Support Type item in the BIOS setup to [HD Audio]. See section 4.4.7
Onboard Device Conguration for details.