• For detailed instructions on RAID congurations, refer to the RAID manual in the
Support DVD.
• If you intend to create a Serial ATA RAID set using these connectors, set the OnChip
SATA Type item in the BIOS to [RAID]. See 2.3.4 SATA Conguration for details.
4. Serial ATA connectors (7-pin SATA1, SATA2, SATA3, SATA5, and SATA6)
These connectors are for the Serial ATA signal cables for Serial ATA 3Gb/s hard disk
and optical disk drives. The Serial ATA 3Gb/s is backward compatible with Serial ATA
1.5Gb/s specication. The data transfer rate of the Serial ATA 3Gb/s is faster than the
standard parallel ATA with 133 MB/s (Ultra DMA133). If you install Serial ATA hard disk
drives, you can create a RAID 0, RAID 1, and RAID 0+1 congurations through the
onboard SB700 chipset.
Install the Windows
®
XP Service Pack 1 before using Serial ATA.
5. Serial port connector (10-1 pin COM1)
The connector is for a serial (COM) port. Connect the serial port module cable to the
connector, then install the module to a slot opening at the back of the system chassis.
The serial port bracket (COM1) is purchased separately.
Chapter 1: Product introduction1-24
To Next Page
Loading...
