Asus Maximus VII Formula Series - Page 107

ASUS MAXIMUS VII FORMULA
3-19
Chapter 3
Power Current Offset [Auto]
Allows you to increase or decrease the output current sensed by the CPU.
It nds the balance between optimal regulating while staying below the
current threshold.
Conguration options: [Auto] [100%] [87.5%] [75.0%] [62.5%] [50.0%]
[37.5%] [25.0%] [12.5%] [0%] [-12.5%] [-25.0%] [-37.5%] [-50.0%] [-62.5%]
[-75.0%] [-87.5%] [-100%]
Power Fast Ramp Response [Auto]
Allows you to increase to enhance the response of the voltage regulator
during the load transient. Conguration options: [Auto] [0.00] - [1.50]
CPU Internal Power Saving Control
Power Saving Level 1 Threshold [Auto]
Lower value provides sufcient overclocking tolerance to enlarge the
overclocking potential. Higher value provides better power-saving condition.
Use <+> or <-> key to adjust the value. The values range from 0A to 80A at
1Amp increment.
Power Saving Level 2 Threshold [Auto]
Lower value provides sufcient overclocking tolerance to enlarge the
overclocking potential. Higher value provides better power-saving condition.
Use <+> or <-> key to adjust the value. The values range from 0A to 50A at
1Amp increment.
Power Saving Level 3 Threshold [Auto]
Lower value provides sufcient overclocking tolerance to enlarge the
overclocking potential. Higher value provides better power-saving condition.
Use <+> or <-> key to adjust the value. The values range from 0A to 30A at
1Amp increment.
Fully Manual Mode [Disabled]
Enable this item to open up support of voltage control via ROG Connect and OC Panel.
Conguration options: [Disabled] [Enabled]