Asus P5AD2 Deluxe - Page 47

ASUS P5AD2 DeluxeASUS P5AD2 Deluxe
ASUS P5AD2 DeluxeASUS P5AD2 Deluxe
ASUS P5AD2 Deluxe
2-252-25
2-252-25
2-25
5.5.
5.5.
5.
Serial ATA RAID connectors (7-pin SATA_RAID1,Serial ATA RAID connectors (7-pin SATA_RAID1,
Serial ATA RAID connectors (7-pin SATA_RAID1,Serial ATA RAID connectors (7-pin SATA_RAID1,
Serial ATA RAID connectors (7-pin SATA_RAID1,
SATA_RAID2, SATA_RAID3, SATA_RAID4)SATA_RAID2, SATA_RAID3, SATA_RAID4)
SATA_RAID2, SATA_RAID3, SATA_RAID4)SATA_RAID2, SATA_RAID3, SATA_RAID4)
SATA_RAID2, SATA_RAID3, SATA_RAID4)
These connectors are for Serial ATA signal cables. These connectors
support up to four Serial ATA hard disk drives that you can configure
as a disk array through the onboard SATA RAID controller. Refer to
Chapter 5 for details on how to set up Serial ATA RAID configurations.
These connectors are set to
RAID ModeRAID Mode
RAID ModeRAID Mode
RAID Mode by default. If you want to
connect Serial ATA boot/data hard disk drives to these connectors, set
the
Silicon Image ControllerSilicon Image Controller
Silicon Image ControllerSilicon Image Controller
Silicon Image Controller item in the BIOS to [SATA Mode]. See
section “4.4.6 Onboard Devices Configuration” for details.
• Before creating a RAID set using Serial ATA hard disks, make sure
that you have connected the Serial ATA signal cable and installed
Serial ATA hard disk drives; ; otherwise, you cannot enter the Silicon
Image RAID utility and SATA BIOS setup during POST.
• You can only create RAID 5 and JBOD configuration using the
SATALink™ SATA RAID Management software. See Chapter 5 for
details. The RAID 5 feature is not Windows
®
Hardware Quality Labs
(WHQL)-certified.
P5AD2
®
P5AD2 Deluxe SATA RAID connectors
GND
RSATA_TXP2
RSATA_TXN2
GND
RSATA_RXP2
RSATA_RXN2
GND
SATA_RAID1
GND
RSATA_TXP1
RSATA_TXN1
GND
RSATA_RXP1
RSATA_RXN1
GND
SATA_RAID2
GND
RSATA_TXP4
RSATA_TXN4
GND
RSATA_RXP4
RSATA_RXN4
GND
SATA_RAID3
GND
RSATA_TXP3
RSATA_TXN3
GND
RSATA_RXP3
RSATA_RXN3
GND
SATA_RAID4