Asus P5AD2 Deluxe - Page 83

ASUS P5AD2 DeluxeASUS P5AD2 Deluxe
ASUS P5AD2 DeluxeASUS P5AD2 Deluxe
ASUS P5AD2 Deluxe
4-174-17
4-174-17
4-17
The P-ATA+S-ATA and P-ATA options are for advanced users only. If
you set to any of these options and encountered problems, revert to
the default setting
S-ATAS-ATA
S-ATAS-ATA
S-ATA. Configuration options: [P-ATA+S-ATA]
[S-ATA] [P-ATA]
The
Onboard IDE Operate Mode Onboard IDE Operate Mode
Onboard IDE Operate Mode Onboard IDE Operate Mode
Onboard IDE Operate Mode and its sub-menu items appear
only when the
Configure SATA As Configure SATA As
Configure SATA As Configure SATA As
Configure SATA As item is set to [Standard IDE].
Onboard Serial-ATA BOOTROOM [Enabled]
Enables or disables the onboard Serial ATA boot ROM. This item
appears only when the Configure SATA As item is set as RAID.
Configuration options: [Disabled] [Enabled]
The
Onboard Serial-ATA BOOTROM Onboard Serial-ATA BOOTROM
Onboard Serial-ATA BOOTROM Onboard Serial-ATA BOOTROM
Onboard Serial-ATA BOOTROM appears only when the
Configure SATA As Configure SATA As
Configure SATA As Configure SATA As
Configure SATA As item is set to [RAID].
ALPE and ASP [Disabled]ALPE and ASP [Disabled]
ALPE and ASP [Disabled]ALPE and ASP [Disabled]
ALPE and ASP [Disabled]
Allows you to enable or disable the Agressive Link Power Management
(ALPE) and Aggressive Slumber/Partial (ASP) management features.
Configuration options: [Disabled] [Enabled]
Stagger Spinup Support [Enabled]
Enables or disables the stagger spinup support.
Configuration options: [Disabled] [Enabled]
AHCI Port 3 Interlock Switch [Disabled]
Enables or disables the Advanced Host Controller Interface (AHCI) Port
3 interlock switch. Configuration options: [Disabled] [Enabled]
The
ALPE and ASP ALPE and ASP
ALPE and ASP ALPE and ASP
ALPE and ASP and its sub-menu appear only when the
Configure SATA As Configure SATA As
Configure SATA As Configure SATA As
Configure SATA As item is set to [AHCI].
IDE Detect Time Out [35]IDE Detect Time Out [35]
IDE Detect Time Out [35]IDE Detect Time Out [35]
IDE Detect Time Out [35]
Selects the time out value for detecting ATA/ATAPI devices.
Configuration options: [0] [5] [10] [15] [20] [25] [30] [35]