Asus P5B - Page 51

ASUS P5B 2-27
4. JMicron JMB363
®
Serial ATA RAID connector (7-pin SATA_RAID)
This connector is for a Serial ATA signal cable. This connector supports
a Serial ATA hard disk drive that you can congure for RAID through the
onboard Serial ATA RAID controller.
The JMicron controller mode item in the BIOS is set to [AHCI] by default,
allowing you to use the connectors to build a RAID set. See section “4.4.5
Onboard Device Conguration” for details.
Before creating a RAID set using Serial ATA hard disks, make sure that you
have connected the Serial ATA signal cables and installed Serial ATA hard disk
drives; otherwise, you cannot enter the JMicron
®
JMB363 RAID utility and SATA
BIOS setup during POST.
R
P5B
P5B SATA RAID Connector
SATA_RAID
GND
RSATA_TXP1
RSATA_TXN1
GND
RSATA_RXP1
RSATA_RXN1
GND
5. Digital audio connector (4-1 pin SPDIF_OUT)
This connector is for an additional Sony/Philips Digital Interface (S/PDIF)
port(s). Connect the S/PDIF Out module cable to this connector, then install
the module to a slot opening at the back of the system chassis.
The S/PDIF module is purchased separately.
R
P5B
P5B Digital Audio Connector
+5V
SPDIFOUT GND
SPDIF_OUT