1-261-26
1-261-26
1-26
Chapter 1: Hardware informationChapter 1: Hardware information
Chapter 1: Hardware informationChapter 1: Hardware information
Chapter 1: Hardware information
4.4.
4.4.
4.
Serial ATA connectorsSerial ATA connectors
Serial ATA connectorsSerial ATA connectors
Serial ATA connectors
(7-pin SATA1 [red], SATA2 [red], SATA3 [black],(7-pin SATA1 [red], SATA2 [red], SATA3 [black],
(7-pin SATA1 [red], SATA2 [red], SATA3 [black],(7-pin SATA1 [red], SATA2 [red], SATA3 [black],
(7-pin SATA1 [red], SATA2 [red], SATA3 [black],
SATA4 [black])SATA4 [black])
SATA4 [black])SATA4 [black])
SATA4 [black])
These connectors are for the Serial ATA signal cables for Serial ATA
hard disk drives.
Important notes on Serial ATAImportant notes on Serial ATA
Important notes on Serial ATAImportant notes on Serial ATA
Important notes on Serial ATA
•
These connectors support the Intel
®
Matrix Storage Technology.
•
The Serial ATA RAID feature (RAID 0, RAID 1) is available only if you
are using Windows
®
2000/XP.
•
Install the Windows
®
2000 Service Pack 4 or the Windows
®
XP
Service Pack1 before using Serial ATA.
• Use only a maximum of two ports for each RAID 0 or RAID 1 set.
•
Plug your Serial ATA boot disk on the master port (SATA1 and
SATA2) to support S3 function. Refer to the table on the next page
for details.
These connectors are set to Standard IDE configuration by default. In
Standard IDE mode, you can connect Serial ATA boot/data hard disk
drives to these connectors.
P5GD2-VM
®
P5GD2-VM SATA connectors
SATA1
GND
RSATA_TXP1
RSATA_TXN1
GND
RSATA_RXP1
RSATA_RXN1
GND
SATA4
GND
RSATA_TXP4
RSATA_TXN4
GND
RSATA_RXP4
RSATA_RXN4
GND
SATA3
GND
RSATA_TXP3
RSATA_TXN3
GND
RSATA_RXP3
RSATA_RXN3
GND
SATA2
GND
RSATA_TXP2
RSATA_TXN2
GND
RSATA_RXP2
RSATA_RXN2
GND
To Next Page
Loading...
