2-162-16
2-162-16
2-16
Chapter 2: BIOS setupChapter 2: BIOS setup
Chapter 2: BIOS setupChapter 2: BIOS setup
Chapter 2: BIOS setup
IDE Detect Time Out [35]IDE Detect Time Out [35]
IDE Detect Time Out [35]IDE Detect Time Out [35]
IDE Detect Time Out [35]
Selects the time out value for detecting ATA/ATAPI devices.
Configuration options: [0] [5] [10] [15] [20] [25] [30] [35]
Enhanced Mode Support On [SATA mode]
The default setting SATA allows you to use native OS on Serial ATA
and Parallel ATA ports. We recommend that you do not change the
default setting for better OS compatibility. In this setting, you may
use legacy OS on the Parallel ATA ports
only ifonly if
only ifonly if
only if you did not install any
Serial ATA device.
The S-ATA+P-ATA and P-ATA options are for advanced users only. If
you set to any of these options and encounter problems, revert to the
default setting
SATASATA
SATASATA
S A T A. Configuration options: [S-ATA+P-ATA]
[SATA mode] [P-ATA]
Combined Mode Option [Primary P-ATA+S-ATA]
Allows you to choose the IDE ports to be used.
Configuration options: [Disabled] [Enabled]
The
Enhanced Mode Support OnEnhanced Mode Support On
Enhanced Mode Support OnEnhanced Mode Support On
Enhanced Mode Support On item appears only when the
Onboard IDE Operate ModeOnboard IDE Operate Mode
Onboard IDE Operate ModeOnboard IDE Operate Mode
Onboard IDE Operate Mode item is set to [Enhanced Mode].
The
Combined Mode OptionCombined Mode Option
Combined Mode OptionCombined Mode Option
Combined Mode Option item appears only when the
OnboardOnboard
OnboardOnboard
Onboard
IDE Operate ModeIDE Operate Mode
IDE Operate ModeIDE Operate Mode
IDE Operate Mode item is set to [Combined Mode].
To Next Page
Loading...
