2-222-22
2-222-22
2-22
Chapter 2: BIOS setupChapter 2: BIOS setup
Chapter 2: BIOS setupChapter 2: BIOS setup
Chapter 2: BIOS setup
DRAM RAS# Precharge [4 Clocks]DRAM RAS# Precharge [4 Clocks]
DRAM RAS# Precharge [4 Clocks]DRAM RAS# Precharge [4 Clocks]
DRAM RAS# Precharge [4 Clocks]
Controls the idle clocks after issuing a precharge command to the
DDR SDRAM. Configuration options: [2 Clocks] [3 Clocks] [4 Clocks]
[5 Clocks]
DRAM RAS# to CAS# Delay [4 Clocks]DRAM RAS# to CAS# Delay [4 Clocks]
DRAM RAS# to CAS# Delay [4 Clocks]DRAM RAS# to CAS# Delay [4 Clocks]
DRAM RAS# to CAS# Delay [4 Clocks]
Controls the latency between the DDR SDRAM active command and
the read/write command. Configuration options: [2 Clocks] [3
Clocks] [4 Clocks] [5 Clocks]
DRAM RAS# Activate to Precharge Delay [15 Clocks]DRAM RAS# Activate to Precharge Delay [15 Clocks]
DRAM RAS# Activate to Precharge Delay [15 Clocks]DRAM RAS# Activate to Precharge Delay [15 Clocks]
DRAM RAS# Activate to Precharge Delay [15 Clocks]
Configuration options: [4 Clocks] ~ [15 Clocks]
DRAM Burst Length [8]DRAM Burst Length [8]
DRAM Burst Length [8]DRAM Burst Length [8]
DRAM Burst Length [8]
Sets the DRAM burst length.
Configuration options: [4] [8]
Booting Graphic Adapter Priority [PCI Express/Int-VGA]
Allows selection of the graphics controller to use as the primary boot
device. Configuration options: [Internal VGA] [PCI Express/Int-VGA]
[PCI Express/PCI] [PCI/PCI Express] [PCI/Int-VGA]
Internal Graphics Mode Select [Enabled, 8MB]
Allows selection of the amount of memory that the internal graphics
device pre-allocates. Configuration options: [Disabled] [Enabled, 1MB]
[Enabled, 4MB] [Enabled, 8MB] [Enabled, 16MB] [Enabled, 32MB]
Fixed Graphic Memory SIze [32MB]
Allows you to select the size of graphic memory used by fixed mode.
Configuration options: [0MB] [32MB] [64MB] [128MB]
DVMT Graphic Memory SIze [32MB]
Allows you to select the size of graphic memory used by DVMT mode.
Configuration options: [0MB] [32MB] [64MB] [128MB] [224MB]