ASUS P5N73-AM 2-3
To update the BIOS using EZ Flash 2:
1. Insert the oppy disk or the USB ash disk that contains the latest BIOS le to the
oppy disk drive or the USB port, then launch EZ Flash 2 in either of these two ways:
•. Press
<Alt> + <F2> during POST to display the following:
2.1.3 ASUS EZ Flash 2 utility
The ASUS EZ Flash 2 feature allows you to update the BIOS without using an OS-based
utility.
Before you start using this utility, download the latest BIOS le from the ASUS website at
www.asus.com.
ASUSTek EZ Flash 2 BIOS ROM Utility B328
Current ROM Update ROM
BOARD: P5N73-AM
VER: 0107
DATE: 05/29/2008
BOARD: Unknown
VER: Unknown
DATE: Unknown
PATH: C:\M2NPVOC
A:
C:
[Enter] Select [S] Save [ESC]Exit
[Tab] Switch [Up/Down/Home/End] Move
Note
WIN98SE <DIR>
NETTERM <DIR>
DRIVERS <DIR>
RECYCLED <DIR>
WUTEMP <DIR>
NEWFOL~1 <DIR>
FLASH TYPE: MXIC MX25L8005 8Mb SPI
WIN98E <DIR>
• Enter the BIOS setup program. Go to the Tools menu to select EZ Flash 2 and
press <Enter> to enable it.
Press <Tab> to switch between drives until the correct BIOS le is found.
2. When the correct BIOS le is found, EZ Flash 2 performs the BIOS updating process
and automatically reboots the system when done.
• This function supports devices such as USB ash disks or oppy disks with FAT 32/16
format and single partition only.
•
DO NOT shut down or reset the system while updating the BIOS to prevent system boot
failure!