Asus P5P43TD PRO - 2.5.2 Chipset; 2.5.3 Onboard Devices Configuration

ASUS P5P43TD PRO 2-15
The following item appears only when you installed an Intel
®
CPU that supports the
Enhanced Intel
®
SpeedStep
®
Technology (EIST).
Intel(R) SpeedStep(TM) Tech [Enabled]
Allows you to use the Enhanced Intel
®
SpeedStep
®
Technology. When set to [Enabled], you
can adjust the system power settings in the operating system to use the EIST feature. Set
this item to [Disabled] if you do not want to use the EIST. Conguration options: [Enabled]
[Disabled]
Intel(R) C-STATE Tech [Disabled]
Allows you enable or disable the Intel
®
C-STATE Technology. When enabled, the CPU idle is
set to C2/C3/C4. Conguration options: [Disabled] [Enabled]
2.5.2 Chipset
The Chipset menu allows you to change the advanced chipset settings. Select an item then
press <Enter> to display the submenu.
North Bridge Conguration
Memory Remap Feature [Enabled]
Allows you to enabled or disable the remapping of the overlapped PCI memory above the
total physical memory. Enable this option only when you install 64-bit operating system.
Conguration options: [Disabled] [Enabled]
Initiate Graphic Adapter [PEG/PCI]
Allows you to decide which graphics controller to use as the primary boot device.
Conguration options: [PCI/PEG] [PEG/PCI]
2.5.3 Onboard Devices Conguration
High Denition Audio [Enabled]
Allows you to enable or disable the high denition audio.
Conguration options: [Enabled] [Disabled]
Front Panel Type [HD Audio]
Allows you to select the front panel type. If High Denition Audio Front Panel used,
please set HD Audio mode. Conguration options: [AC97] [HD Audio]
J-Micron eSATA/PATA Controller [Enabled]
Allows you to enable or disable the J-Micron eSATA/PATA Controller.
Conguration options: [Disabled] [Enabled]
Controller Mode [IDE[
Allows you to select the J-Micron eSATA/PATA Controller mode. This item appears
only when the J-Micron eSATA/PATA Controller item is set to [Enabled]. Conguration
options: [IDE] [AHCI]
JMicron SATA/RAID OptROM [Enabled]
Allows you to enable or disable the JMicron SATA/RAID OptROM. This item appears
only when the J-Micron eSATA/PATA Controller item is set to [Enabled].
Conguration options: [Disabled] [Enabled]