Asus P5Q SE2 - Page 35

ASUS P5Q SE2 1-25
10. Optical drive audio connector (4-pin CD)
These connectors allow you to receive stereo audio input from sound sources such as
a CD-ROM, TV tuner, or MPEG card.
P5Q SE2
CD
Left Audio Channel GND GND Right Audio Channel
P5Q SE2 Internal audio connector
11. ATX power connectors (24-pin EATXPWR, 4-pin EATX12V)
These connectors are for ATX power supply plugs. The power supply plugs are
designed to t these connectors in only one orientation. Find the proper orientation and
push down rmly until the connectors completely t.
P5Q SE2
P5Q SE2 ATX power connectors
ATX12V
PIN 1
+12V DC +12V DC
GND GND
EATXPWR
PIN 1
+3 Volts
+3 Volts
GND
+5 Volts
GND
+5 Volts
GND
Power OK
+5V Staudby
+12 Volts
+12 Volts
+3 Volts
+3 Volts
-12 Volts
GND
PSPN#
GND
GND
GND
-5 Volts
+5 Volts
+5 Volts
+5 Volts
GND
• For a fully congured system, we recommend that you use a power supply unit (PSU)
that complies with ATX 12 V Specication 2.0 (or later version) and provides a minimum
power of 400 W.
• Do not forget to connect the 4-pin EATX12V power plug; otherwise, the system will not
boot.
• Use of a PSU with a higher power output is recommended when conguring a system
with more power-consuming devices. The system may become unstable or may not boot
up if the power is inadequate.
• The ATX 12 V Specication 2.0-compliant (400W) PSU has been tested to support the
motherboard power requirements with the following conguration:
CPU: Intel
®
Pentium
®
Extreme 3.73GHz
Memory: 512 MB DDR2 (x4)
Graphics card: ASUS EAX1900XT
Parallel ATA device: IDE hard disk drive
Serial ATA device: SATA hard disk drive (x2)
Optical drive: DVD-RW