1-26 Chapter 1: Product introduction
• The USB device wake-up feature requires a power supply that can
provide 500mA on the +5VSB lead for each USB port; otherwise,
the system would not power up.
• The total current consumed must NOT exceed the power supply
capability (+5VSB) whether under normal condition or in sleep mode.
• USB1 and USB2 ports are only for P5VD2-VM.
• For P5V-VM SE DH, USBPW12 jumper controls Wi-AP Solo. Do not
change the setting.
4. PCI Express x 1 and External SATA jumper setting
This jumper allows you to enable or disable the PCI Express x 1 or the
External SATA function. Set this jumper to pins 1-2 to activate the PCI
Express x 1 function. Set this jumper to pin 2-3 (default) to activate External
SATA function.
To Next Page
Loading...
