5-64 Chapter 5: Software support
5.5.2 Creating a RAID driver disk in Windows
®
To create a RAID driver disk in Windows
®
:
1. Start Windows
®
.
2. Place the motherboard support CD into the optical drive.
3. Go to the Make Disk menu, then click Intel ICH7R 32/64 bit RAID Driver
Disk to create an Intel
®
ICH7R RAID driver disk or the Make JMicron
JMB36X 32/64-bit RAID Driver to create a JMicron JMB363 RAID driver
disk.
4. Insert a oppy disk into the oppy disk drive.
5. Follow succeeding screen instructions to complete the process.
Write-protect the oppy disk to avoid computer virus infection.
5.5 Creating a RAID driver disk
A oppy disk with the RAID driver is required when installing Windows
®
2000/XP
and later operating system on a hard disk drive that is included in a RAID set.
You do not need to create a RAID driver disk if you will create a Safe, Big, or
Fast RAID set through the ASUS EZ-Backup.
5.5.1 Creating a RAID driver disk without entering the OS
To create a RAID driver disk without entering the OS:
1. Boot your computer.
2. Press <Del> during POST to enter the BIOS setup utility.
3. Set the optical drive as the primary boot device.
4. Insert the support CD into the optical drive.
5. Save changes and exit BIOS.
6. Press any key when the system prompts “Press any key to boot from the
optical drive.”
7. When the menu appears, press <1> to create a RAID driver disk.
8. Insert a formatted oppy disk into the oppy drive then press <Enter>.
9. Follow succeeding screen instructions to complete the process.
To Next Page
Loading...
Need help?
General
