Asus P5W DH - Page 105

ASUS P5W DH Deluxe 4-27
DRAM ECC Mode [Disabled]
Allows you to disable or set the DRAM ECC mode. This item appears only when
you install DRAM modules that support ECC function. Conguration options:
[Disabled] [Enabled] [Auto]
Hyper Path 3 [Auto]
Allows you to enable, disable, or set the ASUS Hyper Path 3 feature.
Conguration options: [Disabled] [Enabled] [Auto]
DRAM Throttling Threshold [Auto]
Disables or sets the DRAM Thermal Throttling feature. Set to [Auto] for system
stability. Conguration options: [Disabled] [Auto]
Boot Graphic Adapter Priority [PCI Express/PCI]
Allows selection of the graphics controller to use as primary boot device.
Conguration options: [PCI Express/PCI] [PCI/PCI Express]
PEG Buffer Length [Auto]
Sets the length of the PCI Express graphics card buffer.
Conguration options: [Auto] [Long] [Short]
Link Latency [Auto]
Sets the PCI Express graphics card link latency.
Conguration options: [Auto] [Slow] [Normal]
PEG Root Control [Auto]
Allows you to enable, disable, or set to automatic the PCI Express graphics card
root control. Conguration options: [Auto] [Disabled] [Enabled]
PEG Link Mode [Auto]
Sets the PCI Express graphics link mode. Setting this item to [Auto] allows the
motherboard to automatically adjust the PCI Express graphics link mode to the
correct frequency based on the system conguration. Four additional settings are
available for overclocking the PE� Link Mode. Conguration options: [Auto] [Slow]
[Normal] [Fast] [Faster]
Slot Power [Auto]
Sets the PCI Express graphics card slot power.
Conguration options: [Auto] [Light] [Normal] [Heavy] [Heavier]