Asus P8B-C/4L - Page 138

5-42 Chapter 5: RAID conguration
By default, the RAID Disk eld shows No before volume creation. This eld is
grayed out under the following conditions:
• The disk does not meet the minimum requirements for use in a RAID
volume.
• The disk is not large enough to mirror existing data on the primary drive.
• The disk is already part of another volume.
4. Repeat step 3 to add the other disks to the volume.
5. When done, press <C> to create the volume, then select Save changes then
exit this menu.
6. The utility creates the volume.
Create and save new volume?
Cancel Exit
Save changes then exit this menu
Discard changes then exit this menu
Exit the Conguration Utility and Reboot
Processing...may take up to 1 minute
Creating RAID Volume...
LSI Corp Cong Utility v7.07.00.00 (2010.04.30)