4-14 Chapter 4: Software support
5. Use the up/down arrow key to select a drive, and then press <Space>
to select. A small triangle marks the selected drive. Press <Enter> after
completing your selection.
6. Use the up/down arrow key to select the stripe size for the RAID array (for
RAID 0, 10 and 5 only),and then press <Enter>. The available stripe size
values range from 4KB to 128KB. The following are typical values:
RAID 0: 128KB
RAID 10: 64KB
RAID 5: 64KB
We recommend a lower stripe size for server systems, and a higher stripe size
for multimedia computer systems used mainly for audio and video editing.
WARNING: ALL DATA ON SELECTED DISKS WILL BE LOST.
Are you sure you want to create this volume? (Y/N):
9. Press <Y> to create the RAID volume and return to the main menu, or <N> to
go back to the CREATE VOLUME menu.
7. When the Capacity item is selected, enter the RAID volume capacity that
you want and press <Enter>. The default value indicates the maximum
allowed capacity.
8. When the Create Volume item is selected, press <Enter>. The following
warning message appears:
To Next Page
Loading...
