3-42 Chapter 3: BIOS setup
Chapter 3
Bootup NumLock State [On]
[On] Sets the power-on state of the NumLock to [On].
[Off] Sets the power-on state of the NumLock to [Off].
Full Screen Logo [Enabled]
[Enabled] Enables the full screen logo display feature.
[Disabled] Disables the full screen logo display feature.
Set this item to [Enabled] to use the ASUS MyLogo 2™ feature.
Wait For ‘F1’ If Error [Enabled]
[Disabled] Disables this function.
[Enabled] The system waits for the <F1> key to be pressed when error occurs.
DirectKey Enable [Go to BIOS Setup]
[Go to BIOS Setup] Enables the DirectKey function and allows you to go to the BIOS
setup when you press the DirectKey button.
[Disable] Disables the DirectKey function. When set to [Disable], the DirectKey
button will only allow you to turn on or shut down your computer
without going into the BIOS setup.
When set to [Go to BIOS Setup] and the computer is on, the system will shut down when
you press the DirectKey button. Press the DirectKey button again or the power button to
reboot and go directly into the BIOS setup.
3.7 Boot menu
The Boot menu items allow you to change the system boot options.
To Next Page
Loading...
