Asus PA328QV Series - OSD QuickFit Plus, Signal, and System Settings

3-8 Chapter 3: OSD (On-Screen Display) menu
• PIP/PBP Mode: Selects PIP, PBP function, or turn it off.
To scale both displays to full screen in PBP mode, set resolution
settings for both as 1280 x 1440 in OS display settings. (And make
sure that the scaling option is "Maintain Display Scaling" if you are
using an Intel graphic card.)
• PIP/PBP Source: Selects the video input source from among HDMI-
1, HDMI-2 and DisplayPort. The table below shows the input source
combinations.
Main-window
Sub-window
HDMI-1 HDMI-2 DisplayPort
HDMI-1 Yes Yes Yes
HDMI-2 Yes Yes Yes
DisplayPort Yes Yes Yes
• PIP Size: Adjusts the PIP size to Small, Medium, or Large. (Only available
for the PIP mode)
7. QuickFit Plus
In this function, you can use different kinds of alignment patterns.
PA328QV
2560x1440
60Hz
Preset
Standard Mode
Signal
DisplayPort
Brightness
100
ExitBack Enter
PIP/PBP
QuickFit Plus
Signal
Settings
Shortcut
Safe Area
Center Marker
Customization
Ruler
• Safe Area: Facilitates designers and users to organize content and layout
on one page and achieve a consistent look and feel. The selections are:
1:1, Action Safe, Title Safe, 3 x 3.
• Center Marker: Adjusts the Type 1, Type 2, Type 3.
• Customization: You can decide the frame size by moving the Menu
(5-way) button up/down/left/right. You can press the Menu (5-way)
button for longer than 3 seconds to switch the measurements between
millimeter and inch.
• Ruler: This pattern presents physical ruler on top and left side. You can
press the Menu (5-way) button for longer than 3 seconds to switch the
measurements between metric and imperial.