40 PN Series
To install an M.2 SDD to the bottom cover
1. Remove the plastic lm from the thermal pad.
2. Align and insert the 2280 M.2 SSD into its slot on the bottom cover.
3. Gently push down the 2280 M.2 SSD on top of the stando and secure it
using one of the bundled screws.
NOTE:
• The specications for the thermal pad used in this Mini PC is as follows:
Thickess: 2.0mm Size: 66mm x 20mm Thermal conductivity: 1.2 W/
mK Hardness: < 50 Sc
• Heat dissipation performance may still vary even when you have replaced
the thermal pad with one that meets the above specications. To prevent
possible damage to the M.2 SSD, you should have the thermal pad replaced
by a service center near you.
Thermal pad
Plastic lm
To Next Page
Loading...
