1-7
1.2.2 Rear panel connectors
21
7 7
10
3 4 5
6 8
9
1. DisplayPort. This port is for a DisplayPort-compatible device.
2. PS/2 Mouse/Keyboard combo port. This port connects to a PS/2 mouse or PS/2
keyboard.
3. Realtek 2.5Gb Ethernet port. This port allows 2.5Gbps Ethernet connection to a Local
Area Network (LAN) through a network hub. Refer to the table below for the Ethernet
port LED indications.
Speed LED
Status Description
OFF
No link
GREEN
2.5 Gbps connection
ORANGE
1 Gbps / 100 Mbps /
10 Mbps connection
Activity Link LED
Status Description
OFF No link
GREEN Linked
BLINKING Data activity
ACT/LINK
LED
SPEED
LED
LAN port
Realtek 2.5Gb Ethernet port LED indications
• Power Button/Soft-off Button header (PWRSW)
The 3-1 pin header allows you to connect the system power button. Press the
power button to power up the system, or put the system into sleep or soft-off mode
(depending on the operating system settings).
• Reset button header (RESET)
The 2-pin header allows you to connect the chassis-mounted reset button. Press the
reset button to reboot the system.
• Chassis intrusion header (CHASSIS)
The 2-pin header allows you to connect the chassis-mounted intrusion detection
sensor or switch. The chassis intrusion sensor or switch sends a high-level signal
to the header when a chassis component is removed or replaced, the signal is then
generated as a chassis intrusion event.
PRIME B760M-A AX
To Next Page
Loading...
