Asus PRIME Z390-A - Page 34

1-18
Chapter 1: Product Introduction
Chapter 1
7. Fan and pump connectors (4-pin CPU_FAN; 4-pin CPU_OPT; 5-pin EXT_FAN;
4-pin W_PUMP+; 4-pin AIO_PUMP; 4-pin CHA_FAN1-2; 4-pin M.2_FAN)
Connectthefancablestothefanconnectorsonthemotherboard,ensuringthatthe
blackwireofeachcablematchesthegroundpinoftheconnector.
TheEXT_FANconnectorisonlyforthefanextensioncard.Formoredetailsonthe
fanextensioncard,pleaserefertotheTo install Fan Extension Cardsectioninthis
guide.
Header Max. Current Max. Power Default Speed Shared Control
CPU_FAN 1A 12W Q-FanControlled A
CPU_OPT 1A 12W Q-FanControlled A
CHA_FAN1 1A 12W Q-FanControlled -
CHA_FAN2 1A 12W Q-FanControlled -
AIO_PUMP 1A 12W Full-Speed -
W_PUMP+ 3A 36W Full-Speed -
M.2 1A 12W Q-FanControlled -
• DONOTforgettoconnectthefancablestothefanconnectors.Insufcientairow
insidethesystemmaydamagethemotherboardcomponents.Thesearenotjumpers!
Donotplacejumpercapsonthefanconnectors!
• Ensuretofullyinsertthefancabletothefanconnector.
• TheFANExtensioncardispurchasedseparately.
• W_PUMP+functionsupportdependsonwatercoolingdevice.
• ConnectthefanofyourwatercoolingkittotheW_PUMP+connector.
E14498_PRIME Z390-A_UM.indb 18 8/22/2018 10:20:58