ROG RAMPAGE IV EXTREME 2-33
Chapter 2
3. ASMedia
®
Serial ATA 6.0 Gb/s connectors (7-pin SATA6G_E1/E2 [red])
These connectors connect to Serial ATA 6.0 Gb/s hard disk drives via Serial ATA 6.0
Gb/s signal cables.
• The SATA6G_E1/E2 (red) connectors are for data drives only. ATAPI device is not
supported.
•
You must install Windows
®
XP Service Pack 3 or later versions before using Serial ATA
hard disk drives.
•
When using NCQ, set the
Asmedia Storage Controller
item in the BIOS to [Enabled].
Refer to section
3.5.5 Onboard Devices Conguration
for details.
4. Subzero Sense connector
The Subzero Sense connector allows you to connect the K probe cable (purchased
seperately) to measure the motherboard temperature via BIOS, OC Key or
TurboV EVO without purchasing expensive multimeters.
Subzero Sense detects the connector’s ambient temperature when it’s plugged.
To Next Page
Loading...
