Asus Rampage IV Extreme - Page 94

3-8 Chapter 3: BIOS setup
Chapter 3
Load Elipida Hyper Profile
Change settings to suit Elpida Hyper Prole by selecting Yes.
Load Tight PSC Profile
Change settings to suit Tight PSC Prole by selecting Yes.
Load Loose PSC Profile
Change settings to suit Loose PSC Prole by selecting Yes.
Load RAW MHZ Profile
Change settings to suit RAW MHZ Prole by selecting Yes.
Timing Rule 1/2/3/4/5/6 [Enabled]
Conguration options: [Enabled] [Disabled]
Primary Timings
DRAM CAS# Latency [Auto]
Conguration options: [Auto] [3 DRAM Clock] – [15 DRAM Clock]
DRAM RAS# to CAS# Delay [Auto]
Conguration options: [Auto] [4 DRAM Clock] – [15 DRAM Clock]
DRAM RAS# PRE Time [Auto]
Conguration options: [Auto] [4 DRAM Clock] – [15 DRAM Clock]
DRAM RAS# ACT Time [Auto]
Conguration options: [Auto] [4 DRAM Clock] – [40 DRAM Clock]
DRAM COMMAND Mode [Auto]
Conguration options: [Auto] [1 DRAM Clock] [2 DRAM Clock] [3 DRAM Clock]