Asus Rampage IV GENE - Page 50

2-24
Chapter 2: Hardware information
Chapter 2
3. ASMedia
®
Serial ATA 6.0 Gb/s connectors (7-pin SATA6G_E1/E2 [red])
These connectors connect to Serial ATA 6.0 Gb/s hard disk drives via Serial ATA 6.0
Gb/s signal cables.
• The SATA6G_E1/E2 (red) connectors are for data drives only. ATAPI device is not
supported.
• You must install Windows
®
XP Service Pack 3 or later versions before using Serial ATA
hard disk drives.
• When using NCQ, set the
ASM1061 Storage Controller
item in the BIOS to [Enabled].
Refer to section
3.5.6 Onboard Devices Conguration
for details.