Asus Rampage V Extreme - Page 56

1-38
Chapter 1: Product introduction
Chapter 1
You can connect the front panel USB cable to the ASUS Q-Connector (USB) rst, and then
install the Q-Connector (USB) to the USB connector onboard if your chassis supports front
panel USB ports.
Never connect a 1394 cable to the USB connectors. Doing so will damage the
motherboard!
6. USB 2.0 connectors (10-1 pin USB1112; USB1314)
These connectors are for USB 2.0 ports. Connect the USB module cable to any of
these connectors, then install the module to a slot opening at the back of the system
chassis. These USB connectors comply with USB 2.0 specication that support up to
480 Mbps connection speed.
The USB 2.0 module is purchased separately.