Asus ROG STRIX B350-F GAMING - APM Configuration; Network Stack Configuration; HDD;SSD SMART Information; USB Configuration

3-16
Chapter 3: BIOS Setup
Chapter 3
Change Settings
This item appears only when you set the Serial Port to [On] and allows you to select
the Serial Port base address. Conguration options: [IO=3F8h; IRQ=4] [IO=2F8h;
IRQ=3] [IO=3E8h; IRQ=4] [IO=2E8h; IRQ=3]
3.6.5 APM Conguration
ErP Ready
Allows BIOS to switch off some power at S5 to get the system ready for ErP requirement.
When set to [Enabled], all other PME options will be switched off.
Conguration options: [Enable(S4+S5)] [Enable(S5)] [Disabled]
Restore AC Power Loss
[Power On] The system goes into on state after an AC power loss.
[Power Off] The system goes into off state after an AC power loss.
[Last State] The system goes into either off or on state, whatever the system state was
before the AC power loss.
Power On By PCI-E
This item allows you to enable or disable the Wake-on-LAN function of the onboard LAN
controller or other installed PCIe LAN cards. Conguration options: [Disabled] [Enabled]
Power On By Ring
[Disabled] Disables Ring to generate a wake event.
[Enabled] Enables Ring to generate a wake event.
Power On By RTC
This item allows you to enable or disable the RTC (Real-Time Clock) to generate a wake
event and congure the RTC alarm date. When enabled, you can set the days, hours,
minutes, or seconds to schedule an RTC alarm date. Conguration options: [Disabled]
[Enabled]
3.6.6 Network Stack Conguration
The items in this menu allow you to congure Ipv4 / Ipv6 PXE support.
3.6.7 HDD/SSD SMART Information
This menu displays the SMART information of the connected devices.
3.6.8 USB Conguration
The items in this menu allow you to change the USB-related features.
The USB Devices item shows the auto-detected values. If no USB device is detected, the
item shows None.