Asus ROG STRIX B360-I GAMING - Page 27

ROG STRIX B360-I GAMING
1-13
Chapter 1
5. USB 2.0 connectors (10-1 pin USB910)
ThisconnectorisforUSB2.0ports.ConnecttheUSBmodulecabletothisconnector,
theninstallthemoduletoaslotopeningatthebackofthesystemchassis.ThisUSB
connectorcomplieswithUSB2.0specicationthatsupportsupto480Mb/sconnection
speed.
ROG STRIX B360-I GAMING USB2.0 connector
USB910
PIN 1
USB+5V USB_P10- USB_P10+ GND NC
USB+5V
USB_P9-
USB_P9+
GND
DONOTconnecta1394cabletotheUSBconnectors.Doingsowilldamagethe
motherboard!
TheUSB2.0moduleispurchasedseparately.
6. Thermal sensor connector (2-pin T_SENSOR)
Thisconnectorisforthethermistorcablethatmonitorsthetemperatureofthedevices
andthecriticalcomponentsinsidethemotherboard.Connectthethermistorcable
andplacethesensoronthedeviceorthemotherboard’scomponenttodetectits
temperature.
PIN 1
T_SENSOR
SENSOR IN
GND
ROG STRIX B360-I GAMING T_SENSOR connector