2-14
Chapter 2: Basic Installation
Chapter 2
5. Peel the plastic films off the thermal pads, secure the cover to the ASUS HYPER M.2
X16 GEN 4 card with the cover screws that you removed earlier, then install the ASUS
HYPER M.2 X16 GEN 4 card into a PCI Express 4.0/3.0 slot.
For more information on RAID configurations on
the installed M.2 storage devices, please refer to
the RAID Configuration Guide by scanning the
QR code.
6. Enter the BIOS Setup during POST to configure your BIOS settings.
• For AMD motherboards, go to Advanced > Onboard Devices Configuration,
then set the PCIe slot(s) that you have installed the Hyper M.2 x16 card(s) to
[PCIe RAID Mode].
To Next Page
Loading...
