3-10
Chapter 3: General Instruction
• Power Key Lock:Disable/Enable the Power key.
• Key Lock: Enable this function to disable all function keys. Press
the Navigation button down for more than five seconds to cancel
the key lock function.
• Power Setting：Select the power setting mode.
If the setting is set to Standard Mode, it may result in higher
power consumption. On the other hand, if the setting is set
to Power Saving Mode, it may cause limited luminance
performance.
Power Setting
Standard mode setting may result in higher power consumption.
Power saving mode may cause limited luminance performance.
Would you like to switch to Standard mode?
NO
YES
• OSD Setup: Configure the OSD menu related settings.
• OSD Position: Set the OSD menu position.
• OSD Timeout: Adjust the OSD timeout.
• Transparency: Adjust the OSD background from opaque to
transparent.
• DDC/CI: Enable/Disable the DDC/CI function.
• DisplayPort Stream: Select DisplayPort 1.2 or DisplayPort 1.4
according to the graphic card DP version.
• DSC Support: Enable/Disable the DSC (Display Stream
Compression) function.
• Information: Display the monitor information.
• All Reset: Select YES to revert all settings to the factory default
mode.
To Next Page
Loading...
