Asus SABERTOOTH X79 - Page 74

3-12 Chapter 3: BIOS setup
Chapter 3
The actual performance boost may vary depending on your CPU specication.
CPU Current Capability [Auto]
This item provides wider total power range for overclocking. A higher value brings a
wider total power range and extends the overclocking frequency range simultaneously.
Conguration options: [Auto] [100%] [110%] [120%] [130%] [140%]
CPU VCORE Boot Up Voltage [Auto]
This item controls the voltage for CPU at initial boot. Set higher value for better
overclockability. The values range from 0.800V to 1.700V with a 0.005V interval.
VCCSA Load-line calibration [Auto]
The behavior of the DRAM controller is decided by VCCSA Load-Line. Set to a higher
value for system performance, or to a lower value for better thermal solution.
Conguration options: [Auto] [Regular] [High] [Extreme]
VCCSA Current Capability [100%]
Allows you to set the VCCSA current capability. A higher value brings wider total DRAM
controller power range and extends the overclocking frequency range simultaneously.
Conguration options: [100%] [110%] [120%] [130%]
CPU VCCSA Boot Up Voltage [Auto]
This item controls the voltage for CPU VCCSA at initial boot. Set higher value for better
overclockability. The values range from 0.800V to 1.700V with a 0.005V interval.
CPU Voltage Frequency [Auto]
Switching frequency will affect the transient response and component thermal. Higher
frequency gets quicker transient response.
Conguration options: [Auto] [Manual]
CPU Fixed Frequency [XXX]
This item appears only when you set the CPU Voltage Frequency item to [manual]
and allows you to set a CPU xed frequency. The values range from 300kHz to 500kHz
with a 10kHz interval.
CPU Spread Spectrum [Diasbled]
[Disabled] Enhances the BCLK overclocking ability.
[Enabled] Sets to [Enabled] for EMI control.
CPU Power Duty Control [T.Probe]
[T.Probe] Maintains the VRM thermal balance.
[Extreme] Maintains the VRM current balance.
CPU Power Phase Control [Auto]
Phase number is the number of working VRM phase. Increasing phase number under
heavy system loading to get more transient and better thermal performance. Reducing
phase number under light system loading to increase VRM efciency
[Auto] Loads the settings for the system automatically.
[Standard] Proceeds phase control depending on the CPU loading.
[Optimized] Loads the ASUS optimized phase tuning prole.
[Extreme] Proceeds the full phase mode.
[Manual Adjustment] Allows manual adjustment for Regular/Medium/Fast/Ultra
Fast options.