Asus Sabertooth X99 - APM Configuration

ASUS SABERTOOTH X99
3-49
Chapter 3
3.6.8 APM Configuration
ErP Ready [Disabled]
This item allows you to switch off some power at S4+S5 or S5 to get the system ready for
ErP requirement. When set to [Enabled], all other PME options are switched off.
Conguration options: [Disabled] [Enabled (S4+S5] [Enabled (S5)]
Restore AC Power Loss [Power Off]
This item allows your system to go to ON state, OFF state, or both states after an AC power
loss. When setting your system to [Last State], it goes to the previous state before the AC
power loss.
Conguration options: [Power Off] [Power On] [Last State]
Power On By PCI-E/PCI [Disabled]
This item allows you to enable/disable the Wake-on-LAN function of the onboard LAN
controller or other installed PCI-E LAN cards.
Conguration options: [Disabled] [Enabled]
Power On By RTC [Disabled]
This item allows you to enable/disable the RTC (Real-Time Clock) to generate a wake event
and congure the RTC alarm date. When enabled, you can set the days, hours, minutes, or
seconds to schedule an RTC alarm date.
Conguration options: [Disabled] [Enabled]