Asus Sabertooth X99 - Page 49

ASUS SABERTOOTH X99
1-33
Chapter 1
6. Front panel audio connector (10-1 pin AAFP)
This connector is for a chassis-mounted front panel audio I/O module that supports
either HD Audio or legacy AC`97 audio standard. Connect one end of the front panel
audio I/O module cable to this connector.
• We recommend that you connect a high-denition front panel audio module to this
connector to avail of the motherboard’s high-denition audio capability.
• If you want to connect a high-denition or an AC’97 front panel audio module to this
connector, set the Front Panel Type item in the BIOS setup to [HD] or [AC97].
7. Thermal Sensor connectors (2-pin T_SENSOR1; T_SENSOR2;T_SENSOR3)
These connectors are for the thermistor cables that monitor the temperature of the
devices and the critical components inside the motherboard. Connect the thermistor
cable and place the sensor on the device or the motherboard’s component to detect its
temperature.