Asus Sabertooth X99 - Page 98

3-28
Chapter 3: BIOS setup
Chapter 3
DO NOT remove the thermal module. The thermal conditions should be monitored.
DRAM AB/CD Current Capability (CHA, CHB, CHC, CHD) [100%]
This item adjusts the total power range for DRAM overclocking. Set a higher value
to provide a wider total power range and extends the overclocking frequency range
simultaneously.
Conguration options: [100%] [110%] [120%] [130%]
DRAM AB/CD Switching Frequency (CHA, CHB, CHC, CHD) [Auto]
This item affects the overclocking range and system stability. Set this item to [Manual]
to manually set a xed DRAM switching frequency for an increased overclocking range
or enhanced system stability.
The following item appears only when you set the DRAM Switching Frequency to [Manual].
Fixed DRAM Switching Frequency (KHz) [300]
This item allows you to set a higher frequency for an increased
overclocking range or a lower frequency for an enhanced system stability.
Use the <+> or <-> to adjust the value. The values range from 300 KHz to
500 KHz with an interval of 50 KHz.
DRAM Power Phase Control (CHA, CHB, CHC, CHD) [Auto]
[Optimized] Set to the ASUS optimized phase tuning prole.
[Extreme] Set to the full phase mode.
DO NOT remove the thermal module when setting this item to [Extreme]. The thermal
conditions should be monitored.
Internal CPU Power Management
The subitems in this menu allow you to set the CPU ratio and their features.
Enhanced Intel SpeedStep Technology [Enabled]
This item allows the operating system to dynamically adjust the processor voltage and
cores frequency, resulting to a decreased average power consumption and decreased
average heat production.
Conguration options: [Disabled] [Enabled]