2-8
Chapter 2: Basic Installation
Chapter 2
DO NOT over tighten the screws! Doing so can damage the motherboard.
2. Place the motherboard into the chassis, ensuring that its rear I/O ports are aligned to
the chassis’ rear I/O panel.
3. Place nine (9) screws into the holes indicated by circles to secure the motherboard to
the chassis.
This instruction is for reference only, please place the amount of screws according to your
installation situation.
2.4 Motherboard installation
1. (on selected models) Install the bundled I/O Shield to the chassis rear I/O panel.
Only install the I/O Shield if your motherboard does not have a pre-installed I/O shield.
To Next Page
Loading...
