Asus V-Series P5G31 - Page 84

ASUS V-Series P5G31 5-19
The Module Version and USB Devices Enabled items show the
auto-detected values. If no USB device is detected, the item shows None.
USB Functions [8 USB Ports]
Allows you to disable or select the different values of the USB functions.
Conguration options: [Disabled] [2 USB Ports] [4 USB Ports] [6 USB Ports] [8
USB Ports]
USB 2.0 Controller [Enabled]
Allows you to enable or disable USB 2.0 controller. Conguration options:
[Enabled] [Disabled]
Legacy USB Support [Auto]
Allows you to enable or disable support for Legacy USB storage devices, including
USB ash drives and USB hard drives. Setting to Auto allows the system to
detect the presence of USB devices at startup. If detected, the USB controller
legacy mode is enabled. If no USB device is detected, the legacy USB support is
disabled.
Conguration options: [Disabled] [Enabled] [Auto]
USB 2.0 Controller Mode [HiSpeed]
Allows you to congure the USB 2.0 controller in HiSpeed (480 Mbps) or Full
Speed (12 Mbps). Conguration options: [FullSpeed] [HiSpeed]
BIOS EHCI Hand-Off [Enabled]
Allows you to enable support for operating systems without an EHCI hand-off
feature. Conguration options: [Disabled] [Enabled]
USBMassStorageDeviceConguration
USB Mass Storage Reset Delay [20 Sec]
Sets the number of seconds POST waits for the USB mass storage device
after start unit command. Conguration options: [10 Sec] [20 Sec] [30 Sec]
[40 Sec]
Emulation Type [Auto]
Selects the Emulation type. When set to Auto, USB devices less than 530MB
USB Mass Storage Device Conguration
USB Mass Storage Reset Delay [20 Sec]
Device #1 Natac
Emulation Type [Auto]
Number of seconds
POST waits for the
USB mass storage
device after start
unit command.