Asus VA32A Series - Setup; Detaching the Stand;Base (for VESA Wall Mount)

2-1
Chapter 2: Setup
2.1 Detaching the Stand/Base (for VESA
Wall Mount)
The detachable stand of this monitor is specially designed for VESA wall
mount.
1. Disconnect power and signal cables. Carefully put the front of the
monitor face down on a clean table.
2. Remove the screw securing the hinge cover to the stand. Then
remove the hinge cover.
3. Remove the four (4) screws securing the stand hinge to the rear of
the monitor.
4. Detach the assembly (stand and base) from the monitor.
1
2
3
4
• We recommend that you cover the table surface with soft cloth to prevent
damage to the monitor.
• The VESA wall mount kit (100 x 100 mm) is purchased separately.
• Use only the UL Listed Wall Mount Bracket with minimum weight/load
22.7kg (Screw size: M4 x 0.7 mm).